Test Build Galaxy S3 Android 4.3 update leaked and install - Android Planet

The Samsung Galaxy S3 Android 4.3 update has been leaked and install for those who can not wait. This is called a test build, so watch out with the installation. Software might not yet fully optimized for the Galaxy S3. According SamMobile the firmware but very stable and can be used.

The Galaxy S3 Android 4.3 update can be found, including the overall interface that is now equal to the Galaxy S4 and Galaxy Note 3.

leaked firmware does not yet have the security program and Knox still has the same old widgets and launcher.

To install the Galaxy S3 Android 4.3 update, you can download the firmware here and follow steps below. Please note: the firmware ensures that your entire unit is gewiped, or is emptied

.

– Extract (unzip) the firmware file
– Download Odin3 v3.09 (From here)
-. Extract Odin ZIP file
– Open Odin3 v3.09
– Restart phone in download mode (Press and hold Volume Down + Home + Power buttons)
– Connect phone and wait until you get a bluesign in Odin
– AP_I9300XXUGMJ9_1902166_REV00_user_low_ship.tar.md5 Add to AP
– Add to BL_I9300XXUGMJ9_1902166_REV00_user_low_ship.tar.md5 BL
– MODEM_I9300BUUGMJ3_REV02_REV04_CL1413323.tar.md5 Add to CP
– CSC_VFG_I9300VFGGMJ5_1986192_REV00_user_low_ship.tar.md5 Add to CSC
– Make sure re-partition is NOT ticked
– Click Start button, sit back and wait a few minutes
-. If you encounter any issues with the firmware (Any FC Boot Loop etc)
– Boot into recovery mode (Home + Power + full up)
– Choose to wipe / factory reset. (THIS WILL ERASE ALL OF YOUR DATA INCLUDING YOUR INTERNAL SD CARD!)
– Then reboot and you choose shouldering be good to go

Installing such builds at your own risk. Android Planet is not liable for any damage to your device.